How To Attach Steel Roof Panels

To learn more from our contractor co author like how to choose between corrugated pvc or metal roofing keep reading the article.

How to attach steel roof panels.

In most cases this is adequate to secure the strips since the downward pressure from the metal will push down on the closure strips. Fit the corrugated roofing panels over the closure strips and screw them in place. Match the speed of the drill to the substrate or screw type use a 2 500 rpm screw gun for wood and steel substrates that are less than 1 4 inch thick use a 2 000 rpm screw gun for steel substrates that are 1 4 inch thick and heavier use a 1 000 rpm to 2 000 rpm screw gun for 304 stainless steel screws. Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.

If you are installing over an existing surface mark the studs with a pencil before installing panels. Screw down the panels using the pre drilled holes then continue across the roof until it is completely covered. Instead you can just secure the metal roof directly to the wooden beams cut the roofing felt to fit with a utility knife. Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are.

Install the roofing screws vertically along each rib in the panel. It is best to attach the closure strips to the roof with galvanized screws unless the manufacturer advises against this. Bend panel edge we will prepare the end of this panel by cutting up one inch on either side folding under and. The roofing felt will lay horizontally along the plywood deck of the roof.

Install metal panels with ease. Install offset cleat install the offset cleat along the eave and then you are ready to install the metal. Attach the roofing felt with roofing staples. Use your neoprene washer head screws to secure the metal to the sheathing.

Place the first screw. Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses. Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof. Whether installing metal panels on walls ceilings or as a roof the process is the same.

For exposed fasteners avoid over tightening the fastener. Be sure the larger edge is laid so that the small edge of the next panel will overlap it.